Physical
Size:
Width (2.5in/63.5 mm)
Height (6.5 in/165 mm)
Depth (1.24 in/31.5 mm)

Weight:
13.5 ounces (with batteries).

Keyboard:
Membrane switch pad with
twelve tactile keys.

Operating Temperature:
14 to 140F (-10C to 60C)

Case:
Extruded aluminum body with
nickel-plated aluminum end
caps (gasket sealed).

Data Output:
Bi-directional RS232 serial port.
Windows ® PC interface software.Display:
1/8in VGA grayscale display
(240 x 160 pixels). Viewable
area 2.4 x 1.8in (62 x 45.7mm).
EL backlit (on/off/auto).

Ultrasonic Specifications
Measurement Modes:
Pulse-Echo (standard)
Pulse-Echo w/Gate (fine adjust)

Pulser:
Square wave pulser with
adjustable pulse width (spike,
thin, wide).Receiver:
Manual or Auto Set gain control
with 40dB range.

Timing:
10 bit 250 MHz digitizer.

Warranty
2 year limited

Power Source
Three 1.5V alkaline or
1.2V NiCad AA cells.
Typically operates for 150 hours
on alkaline and 100 hours on
NiCad (charger not included.)
Auto power off if idle 5 min.
Battery status icon.

Measuring
Range:
From 1” to 48” (25.4mm
to 122cm) bolts.
Time - Nanoseconds.
Elongation - Change in length
(inches/millimeters).
Load - Force load applied
(pounds kIP or kN Killonewtons).
Stress - Force for unit area stress
applied (pounds kPSI or mega-pascals
MPa).
Strain % - percentage strain
applied (inches per inch or millimeters
per millimeter)Resolution:
+/- .00001 inches (0.0001 mm)

Velocity Range:
.0492 to .3936 in/ms
1250 to 9999 meters/sec
Fixed, Single, and Two point zero

Calibration options.
Select bolt material types from a
preset or custom list.

Units:
English & Metric / Fahrenheit&
Centigrade.

Display
A-Scan - Rectified +/- (half wave
view), or RF (full waveform view).
Large Digits - Display and toggle
between nanoseconds, elongation,
load, stress, and strain.Digit Height:
0.400 in (10mm).
Limits Bar(alarm limits) -
Set Hi & Lo alarm limits for displaying
an acceptable tolerance
range.
Repeatability Bar Graph - Bar
graph indicates stability of measurement.

Data Logger (Internal)
Total of 8,000 readings, multiple
bolt groups. Stores both wave-form
views, nanoseconds, elongation,
load, stress, and strain for
each reading.

Memory:
16 megabit non-volatile ram.

Transducer
Transducer Types:
Single Element (1 to 10 MHz &
1/8” to 1” diameters).
Locking quick disconnect
“00” LEMO connectors.
Standard 10 foot cable.
Custom transducers and cable
lengths available on request.
Temperature probe for automatic
temperature compensation.

Features:
Setups:
64 custom user defined setups.
Factory setups can also be edited
by the user.

Gate:
Gate used to fine adjust where
the detection point occurs.

Alarm Limits:
Set hi and lo tolerances with
audible beeper, viewable scan
bar, and visual LEDs.

Auto Set:
Locates the detection signal, optimizes
the gain setting, and
adjusts the overall display to
show the waveform and detection
point automatically.

Field Calibration:
Vector & linear regression.

Certification
Factory calibration traceable to
national standards.